***************************************** RELEASE NOTES ***************************************** Chelsio T3 Family 10/1G RNIC driver installer for Windows Version : 1.5.13.1 Date : 10/09/2009 ================================================================================================ 1.CHANGES ------------------------------------------------ - Added support for Windows 2008 R2 64 bit operating system. - Removed support for WSD. 2.Errata (Open Issues) ------------------------------------------------ Bug ID: 10815 Status: Unresolved Description: BSOD happens because of windows memory allocation failures if test is run with Low memory(2GB), DV ON and lots of jobs together on 8 nodes on port 0 and port 1 together. ________________________________________________________________________________________________ Bug ID: 10353 Status: Unresolved Description: BSOD while running 15 instances of IMB sendrecv test along with constantly clearing arp entries. ________________________________________________________________________________________________ Bug ID: 6761 Status: Unresolved Description: Asking for a reboot while doing disable/enable of chiwarp driver ************************************************************************************************ Copyright (C) 2010 Chelsio Communications. All Rights Reserved The information in this document is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Chelsio Communications. Chelsio Communications assumes no responsibility or liability for any errors or inaccuracies that may appear in this document or any software that may be provided in association with this document. Except as permitted by such license, no part of this document may be reproduced, stored in a retrieval system,or transmitted in any form or by any means without the express written consent of Chelsio Communications.